BJZCZ - AUTOMOBILE POLISH, LIQUID, W/SILICONE

  • MSDS: BJZCZ
  • Manufacturer: PRODUCTION CHEMICAL MFG INC
  • Product Name: AUTOMOBILE POLISH, LIQUID, W/SILICONE
  • National Stock Number: 7930-00-753-5178
Product Identification

Product ID:AUTOMOBILE POLISH, LIQUID, W/SILICONE
MSDS Date:06/02/1986
FSC:7930
NIIN:00-753-5178
MSDS Number: BJZCZ

Responsible Party
PRODUCTION CHEMICAL MFG. INC.
1000 EAST CHANNEL ST.
STOCKTON, CA 95205
US

Emergency Phone: 209-943-7337

Info Phone: 209-943-7337

Preparer: LEWYN B. BOLER

Cage: PR0DU

Contractor
PRODUCTION CHEMICAL MFG. INC.
STOCKTON, CA 95205 US

Telephone: 209-943-7337

Cage: PR0DU

Ingredients

ABRASIVE

Fraction By Weight: 20%


SOLVENT

CAS: 64742-86-5

RTECS: LX3296500

Fraction By Weight: 57%


PARAFFIN WAX

CAS: 8002-74-2

RTECS: RV0350000

Fraction By Weight: 1.5%

OSHA PEL 2 MG/M3 (FUME)

ACGIH TLV: 2 MG/M3 (FUME); 9192


EMULSIFIER

Fraction By Weight: 1%


SILICONE FLUID

CAS: 63148-62-9

Fraction By Weight: 6%


WATER

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 14.5%

Hazards

Health Hazards Acute and Chronic:EYES:CAN CAUSE SEVERE IRRITATION,
BLURRED VISION. BREATHING:CAN CAUSE NASAL & RESPIRATORY IRRITATION,
DIZZINESS, WEAKNESS. SKIN:CAN CAUSE MODERATE IRRITATION, DEFATTING,
DERMATITIS.
Effects of Overexposure:EYES:CAN CAUSE SEVERE IRRITATION, BLURRED
VISION. BREATHING: CAN CAUSE NASAL & RESPIRATORY IRRITATION,
DIZZINESS, WEAKNESS. SKIN:CAN CAUSE MODERATE IRRITATION, DEFATTING,
DERMATITIS.

First Aid

First Aid:SKIN:WASH EXPOSED AREA WITH SOAP & WATER. EYES:FLUSH WITH
LARGE AMOUNTS OF WATER, LIFTING UPPER AND LOWER LIDS. GET MEDICAL
ATTENTION. SWALLOWED:DO NOT INDUCE VOMITING, KEEP PERSON WARM,
QUIET AND GET MEDICAL ATTENTION. BREATHED:REMOVE INDIVIDUAL TO
FRESH AIR. IF BREATHING IS DIFFICULT ADMINISTER OXYGEN. IF
BREATHING IS STOPPED GIVE ARTIFICIAL RESPIRATION AND GET MEDICAL
ATTENTION.

Fire Fighting

Flash Point Method:TCC
Flash Point:102F/38C
Autoignition Temp:Autoignition Temp Text:500F
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER SPRAY
Fire Fighting Procedures:SELF-CONTAINED BREATHING APPARATUS WITH A FULL
FACEPIECE OPERATED IN PRESSURE DEMAND.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR & MAY TRAVEL
ALONG THE GROUND OR BE MOVED BY VENTILATION & IGNITED BY HEAT,PILOT
LIGHTS OR IGNITION SOURCES AWAY FROM HANDLING POINT

Accidental Release

Spill Release Procedures:ABSORB LIQUID ON PAPER, VERMICULITE, FLOOR
ABSORBENT, OR OTHER ABSORBENT MATERIAL AND TRANSFER TO HOOD.
ELIMINATE ALL IGNITION SOURCES AND PERSONS NOT WEARING PROTECTIVE
EQUIPMENT FROM AREA UNTIL CLEA N-UP HAS BEEN COMPLETED.

Handling

Handling and Storage Precautions:CONTAINERS OF THIS MATERIAL MAY BE
HAZARDOUS WHEN EMPTIED SINCE EMPTIED CONTAINERS RETAIN PRODUCT
RESIDUES (VAPOR, LIQUID, AND/OR SOLID).
Other Precautions:ALL HAZARD PRECAUTIONS GIVEN IN THE DATA SHEET MUST
BE OBSERVED

Exposure Controls

Respiratory Protection:A NIOSH/MSHA JOINTLY APPROVED AIR SUPPLIED
RESPIRATOR IS ADVISED IN ABSENCE OF PROPER ENVIRONMENTAL CONTROL.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV'S.
Protective Gloves:NEOPRENE OR NITRILE RUBBER
Eye Protection:CHEMICAL SPLASH GOGGLES
Other Protective Equipment:WEAR IMPERVIOUS CLOTHING AND BOOTS TO
PREVENT PROLONGED SKIN CONTACT.
Supplemental Safety and Health

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:212F/100C
Melt/Freeze Pt:M.P/F.P Text:NONE
Decomp Temp:Decomp Text:500F/260C
Vapor Density:.8
Spec Gravity:0.78
pH:7
Evaporation Rate & Reference:0.22 (BUAC=1)
Solubility in Water:THICKENS NON-DISPERS
Appearance and Odor:THIN YELLOW LIQUID SOLVENT-LIKE ODOR
Percent Volatiles by Volume:71.5
Corrosion Rate:SULF1PPM

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS
Hazardous Decomposition Products:NORMAL COMBUSTION FORMS CARBON DIOXIDE
& WATER VAPOR. INCOMPLETE COMBUSTION CAN PRODUCE CARBON MONOXIDE.

Disposal

Waste Disposal Methods:ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD.
ALLOW TIME FOR VAPORS TO COMPLETELY CLEAR HOOD DUCT WORK. DISPOSE
OF REMAINING MATERIAL IN ACCORDANCE WITH APPLICABLE REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.